Preliminary Technical Data

ADL6010

Rev. PrB | Page 9 of 10

EVALUATION BOARD

The ADL6010-EVALZ is a fully populated, 4-layer, Rogers

4003-based evaluation board. For normal operation, it requires

a 5V/27mA power supply. The 5V power supply must be

connected to the VPOS and GND test loops. The RF input

signal is applied to the 2.92 mm connector (RFIN). The output

voltage is available on the SMA connector (VOUT) or on the

test loop (V_VOUT). Configuration options for the evaluation

board are listed in Table

5.

Figure 13 ADL6010 Evaluation Board Schematics

Table 5. Evaluation Board Configuration Options

Component

Function/Notes

Default Value

R2, R3

Output interface. A 100 ohm series resistor should be used in the presence of large

capacitive loads. R3 can be replaced with a 0 ohm resistor.

R2 = 100 Ω (size: 0402)

R3 = 100 Ω (size: 0402)

C2

Bypass capacitor. It provides supply ac decoupling by forming a return path for the

ac signal and reduces the noise at the input end. The nominal value is 0.1μF.

C2 = 0.1μF (size: 0402)

RFIN

RF Input. Southwest microwave 2.92 mm connector is used for input interface.