ZSC31150

Fast Automotive Sensor Signal Conditioner

Data Sheet

August 31, 2010

© 2010 Zentrum Mikroelektronik Dresden AG — Rev. 1.07

All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without

the prior written consent of the copyright owner. The information furnished in this publication is subject to changes without

notice.

12 of 24

2.3.2.

Offset Compensation

The ZSC31150 supports two methods of sensor offset compensation (zero shift):



Digital offset correction



XZC - Analog compensation for large offset values (up to in maximum approximately 300% of span,

depending on gain adjustment)

Digital sensor offset correction will be processed during the digital signal correction/conditioning by the

calibration microcontroller (CMC). Analog sensor offset pre-compensation will be needed for compensation of

large offset values, which would overdrive the analog signal path by uncompensated gaining. For analog

sensor offset pre-compensation, a compensation voltage will be added in the analog pre-gaining signal path

(coarse offset removal). The analog offset compensation in the AFE can be adjusted by 6 EEPROM bits.

Table 2.2

Analog Zero Point Shift Ranges (XZC)

PGA gain

[mV/V]

Offset shift per step

in % of full span

Approx. maximum

offset shift [mV/V]

Approx. maximum shift

420

1.8

12.5 %

7.8

388 %

280

2.7

7.6 %

7.1

237 %

210

3.6

12.5 %

15.5

388 %

140

5.4

7.6 %

14.2

237 %

105

7.1

12,5 %

31

388 %

70

10.7

7.6 %

28

237 %

52.5

14.3

12,5 %

32

388 %

35

21.4

7.6 %

57

237 %

26.3

28.5

5.2 %

52

161 %

14

53.75

12.5 %

194

388 %

9.3

80

7.6 %

189

237 %

7

107

5.2 %

161

161 %

2.8

267

0.83 %

72

26 %

2.3.3.

Measurement Cycle

The Multiplexer selects, depending on EEPROM settings, the following inputs in a certain sequence.



Temperature measured by external diode or thermistor, internal pn-junction or bridge





Pre-amplified bridge sensor signal

The complete measurement cycle is controlled by the CMC. The cycle diagram at Figure 2.2 shows its

principle structure.

The EEPROM adjustable parameters are:



n=<1,31>: Pressure measurement count

After power on the start routine is called, that contains all needed measurements once.

Remark:

The tasks “CMV”, “SSC/SCC+” and “SSC/SCC-“ are contained independent from EEPROM

configuration always in every cycle.