12

• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please review our product specifications or consult the approval sheet for product specifications before ordering.

1. Electrical Specifications

of crystal and LC or RC oscillators. Temperature

stability is ±0.3 to ±0.5% against initial values within

-20 to +80°C. The initial frequency precision is

±0.5% for standard products. The frequency of the

measuring circuit, but the oscillation frequency may

shift when used in the actual IC circuit. Usually, if the

frequency precision needed for clock signal of a 1 chip

microcomputer is approximately ±2 to 3% under

used in most cases. If exact oscillation frequency is

required for a special purpose, Murata can manufacture

the ceramic resonator for the desired frequency.

The following are the general electrical specifications of

oscillation frequency, please refer to the next chapter

“Application to Typical Oscillation Circuits”.)

3

Electrical Specifications of MHz Band Lead

Electrical specifications of CSTLS series are shown in

the tables. Please note that oscillation frequency

measuring circuit constants of the CSTLS □G56 series

(with H-CMOS IC) depends on frequency.

■

Resonant Impedance Specifications of

CSTLS/ Series

Type

Frequency Range (MHz) Resonant Impedance (Ω max.)

CSTLS□G

CSTLS □X

16.00 — 32.99

33.00 — 50.00

is built-in load capacitance.

Fig. 3-1 shows the electrical equivalent circuit.

The table shows the general specifications of the CSTLS

series. Input and output terminals of the three-terminal

But connecting reverse, the oscillating characteristics

are not affected except that the frequency has a slight

lag.

CSTLS Series

P17E.pdf

2012.10.31