Bluegiga Technologies Oy

Page 26 of 31

gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list,

having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this

device. See table 8 for the approved antennas for BLE112.

OEM Responsibilities to comply with FCC and Industry Canada Regulations

The BLE112 module has been certified for integration into products only by OEM integrators under the

following condition:



The transmitter module must not be co-located or operating in conjunction with any other antenna or

transmitter.

As long as the condition above is met, further transmitter testing will not be required. However, the OEM

integrator is still responsible for testing their end-product for any additional compliance requirements required

with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).

IMPORTANT NOTE: In the event that these conditions can not be met (for certain configurations or co-

location with another transmitter), then the FCC and Industry Canada authorizations are no longer considered

valid and the FCC ID and IC Certification Number can not be used on the final product. In these

circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the

transmitter) and obtaining a separate FCC and Industry Canada authorization.

End Product Labeling

The BLE112 module is labeled with its own FCC ID and IC Certification Number. If the FCC ID and IC

Certification Number are not visible when the module is installed inside another device, then the outside of the

device into which the module is installed must also display a label referring to the enclosed module. In that

case, the final end product must be labeled in a visible area with the following:

“Contains Transmitter Module FCC ID: QOQBLE112”

“Contains Transmitter Module IC: 5123A-BGTBLE112”

or

“Contains FCC ID: QOQBLE112

“Contains IC: 5123A-BGTBLE112”

The OEM of the BLE112 module must only use the approved antenna(s) listed in table 8, which have been

certified with this module.

The OEM integrator has to be aware not to provide information to the end user regarding how to install or

remove this RF module or change RF related parameters in the user manual of the end product.

8.2.1 FCC et IC

Déclaration d’IC :

Ce dispositif est conforme aux normes RSS exempt

es de licence d’Industrie Canada. Son fonctionnement est

assujetti aux deux conditions suivantes : (1) ce dispositif ne doit pas provoquer de perturbation et (2) ce