7

LTC1065

PI FU CTIO S

Input Pin (Pin 1, N Package)

Pin 1 is the filter input and it is connected to an internal

switched-capacitor resistor. If the input pin is left floating,

the filter output will saturate. The DC input impedance of

pin 1 is very high; with

±5V supplies and 1MHz clock, the

DC input impedance is typically 1G

series with the input pin will not alter the value of the filter’s

to a maximum value (Table 1), otherwise the filter’s pass-

band will be affected. Refer to the Applications Information

section for more details.

1065 F01

2

3

4

8

7

6

5

LTC1065

Figure 1.

1.82k

–

–

3.01k

2.49k

–

4.32k

3.65k

2.37k

9.09k

8.25k

7.5k

17.8k

16.9k

16.9k

95.3k

90.9k

90.9k

threshold levels are illustrated in Table 2. Square wave

clocks with duty cycles between 30% and 50% are strongly

recommended. Sinewave clocks are not recommended.

Output Pin (Pin 7, N Package)

Pin 7 is the filter output. This pin can typically source over

20mA and sink 2mA. Pin 7 should not drive long coax

cables, otherwise the filter’s total harmonic distortion will

degrade. The maximum load the filter output can drive and

still maintain the distortion levels, shown in the Typical

Performance Characteristics, is 20k.

Clock Input Pin (Pin 5, N Package)

An external clock, when applied to pin 5, tunes the filter

cutoff frequency. The clock-to-cutoff frequency ratio is

Table 2. Clock Pin Threshold Levels

POWER SUPPLY

1.5V

0.5V

3V

1V

4.5V

1.5V

4.8V

1.6V

4V

3V

9.6V

7.2V

12V

9V

Clock Output Pin (Pin 4, N Package)

Any external clock applied to the clock input pin appears

at the clock output pin. The duty cycle of the clock output

equals the duty cycle of the external clock applied to the

clock input pin. The clock output pin swings to the power

supply rails. When the LTC1065 is used in a self-clocking

mode, the clock of the internal oscillator appears at the

clock output pin with a 30% duty cycle. The clock output

pin can be used to drive other LTC1065s or other ICs. The

drive is illustrated in Figure 2.

CLOCK FREQUENCY (MHz)

1

200

180

160

140

120

100

80

60

40

20

0

310

1065 F02

24

5

6 78 9

Figure 2. Maximum Load Capacitance at the Clock Output Pin