E5CZ-R2T datasheet(56/64 Pages) OMRON

56 / 64 page

E5EZ-PRR

Wiring

Input should be connected to terminals 9, 10, and 11 depending on input type. Connect the open

side of the position proportional valve to OUT1, and connect the closed side to OUT2.

Settings

Select the value control type and perform floating control using Position-proportional value with travel

time

* of 45 seconds. Set SP ramp to change SP within a width of 10.0

°C/minute.

*Time from completely open to completely close.

The related setting data and settings are as follows:

Direct/ reverse operation

= or-r: Reverse operation (initial setting)

Closed/ floating

= flot: Floating (initial setting)

Travel time

= 45 seconds

SP ramp set value

= "10"

The travel time and SP ramp set value are set in the following, and the initial settings are used for

all other parameters.

1. Press the

key for at least 3 seconds to switch from the operation level to the initial setting

level.

2. Press the M key repeatedly to select "mot: Travel time". Press the U key to set the value to

"45".

3. Press the

key for at least 1 second to return to the “operation level”. When “present value/

set value/valve open percentage” is displayed, press the U key to set the set value to “250”.

4. Press the

key for less than 1 second to switch from operation level to adjustment level.

5. Press the M key repeatedly to select sprt: SP ramp set value. Press the U key, to set the

value to “10”.

OPEN

Valve

Position proportional valve

Ceramic kiln

(combustion)

Sensor

Burner

in-t

l.ini

mot

l.ini

Travel time

SP ramp set value

Operation level

Adjustment level

sprt

l.adj

100.0

250

l.adj

off

Process value/ set value/

valve open percentage

E5CZ-R2T 数据表(PDF) 56 Page - Omron Electronics LLC

E5CZ-R2T 数据表(HTML) 56 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

数据表下载