PAM8014

Document number: DS38114 Rev. 1 - 2

7 of 9

www.diodes.com

January 2016

© Diodes Incorporated

Shutdown Operation

In order to reduce power consumption while not in use, the PAM8014 contains shutdown circuitry amplifier off when logic low is placed on the EN

pin. By switching the shutdown pin connected to GND, the PAM8014 supply current draw will be minimized in idle mode.

Under Voltage Lock-out (UVLO)

The PAM8014 incorporates circuitry designed to detect low supply voltage. When the supply voltage drops to 2.0V or below, the PAM8014 goes

Short Circuit Protection (SCP)

The PAM8014 has short circuit protection circuitry on the outputs to prevent the device from damage when output-to-output shorts or output-to-

GND shorts occur. When a short circuit occurs, the device immediately goes into shutdown state. Once the short is removed, the device will be

reactivated.

Over Temperature Protection (OTP)

Thermal protection on the PAM8014 prevents the device from damage when the internal die temperature exceeds +150°C. There is a +15°C

tolerance on this trip point from device to device. Once the die temperature exceeds the set point, the device will enter the shutdown state and the

outputs are disabled. This is not a latched fault. The thermal fault is cleared once the temperature of the die decreased by +40°C. This large

hysteresis will prevent motor boating sound well and the device begins normal operation at this point with no external system interaction.

POP and Click Circuitry

The PAM8014 contains circuitry to minimize turn-on and turn-

off transients or “click and pops”, where turn-on refers to either power supply turn-on

or device recover from shutdown mode. When the device is turned on, the amplifiers are internally muted. An internal current source ramps up the

reference voltage is stable, the device will begin full operation. For the best power-off pop performance, the amplifier should be set in shutdown

mode prior to removing the power supply voltage.

PAM8014 X X X

A: 9 Pin

Z: U-WLB1313-9

R: Tape & Reel

Part Number

Package

7

” Tape and Reel

Quantity

Part Number Suffix

PAM8014AZR

U-WLB1313-9

3000/Tape & Reel

-7

Note:

4. For packaging details, go to our website at http://www.diodes.com/products/packages.html.

Package

Packing

Pin Configuration