USB3813 datasheet(35/57 Pages) MICROCHIP

35 / 57 page

USB 2.0 Hi-Speed 3-Port Hub Controller Optimized for Portable Applications

Datasheet

 2014 Microchip Technology Inc.

DS00001715A-page 35

7.2.2

Pull-Up Resistors for I2C

The circuit board designer is required to place external pull-up resistors (10 k

Ω recommended) on the

SDA & SCL signals (per SMBus 1.0 Specification) to Vcc in order to assure proper operation.

7.3

SMBus Slave Interface

The USB3813 includes an integrated SMBus slave interface, which can be used to access internal

device run time registers or program the internal OTP memory. SMBus detection is accomplished by

detection of pull-up resistors (10 K

Ω recommended) on both the SMBDATA and SMBCLK signals. To

disable the SMBus, a pull-down resistor of 10 K

Ω must be applied to SMBDATA. The SMBus interface

can be used to configure the device as detailed in Section 6.1, "Configuration Method Selection," on

page 24.

Note: All device configuration must be performed via the Pro-Touch Programming Tool. For additional

information on the Pro-Touch programming tool, contact your local Microchip sales

representative.

USB3813 数据表(PDF) 35 Page - Microchip Technology