Register description

L2G3IS

22/26

DocID024950 Rev 3

7.10

CTRL_TEMP (20h)

To enable writing to the CTRL_TEMP (20h) register, the REG_EN bit in CTRL_REG1 (0Bh)

has to be set to ‘1’.

7.11

OUT_TEMP (26h)

Table 28. CTRL_TEMP register

1. These bits must be set to ‘0’ for proper operation of the device.

2. This bit must be left at ‘1’ for proper operation of the device.

Table 29. CTRL_TEMP description

TEMP_EN

Temperature sensor enable. Default 0

(0: temperature sensor is disabled; 1: temperature sensor is enabled).

Refer to: Section 2.4: Temperature sensor on how to enable and read the

temperature sensor output data.

Table 30. OUT_TEMP register

Temp7

Temp6

Temp5

Temp4

Temp3

Temp2

Temp1

Temp0

Table 31. OUT_TEMP description

Temp7-Temp0

Temperature data. The value is expressed as two’s complement left-justified.

The output of the temperature sensor is 0 at 25 °C.

Refer to: Section 2.4: Temperature sensor on how to enable and read the

temperature sensor output data.