DocID025635 Rev 6

9/16

SPWF01SA, SPWF01SC

Regulatory compliance

16

7

Regulatory compliance

RF compliance

The RF certifications obtained are described in Table 7 below.

Note:

The SG901-1066 from Sagrad Inc. is the only approved antenna using the u.fl connector

version.

FCC and IC

This module has been tested and complies with the FCC part 15 and IC RSS-210

regulations. These limits are designed to provide reasonable protection against harmful

interference in approved installations. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions:

1.

The device must not cause harmful interference.

and

2.

The device must accept any interference received, including interference that may

cause undesired operation.

Modifications or changes to this equipment not expressly approved by the party responsible

for compliance may render void the user's authority to operate this equipment.

Modular approval, FCC and IC

FCC ID: VRA-SG9011203

IC: 7420A-SG9011203

In accordance with FCC part 15, the modules SPWF01SA and SPWF01SC are listed above

as a modular transmitter device.

Table 7. RF certification summary

Comment

FCC ID VRA-SG9011203

On board antenna and external SG901-1066 with connector version

IC ID

7420A-SG9011203

On board antenna and external SG901-1066 with connector version

ETSI

Compliant

Approved with on board antenna and connector version