SIGNAL & CONTROL SOLUTIONS

2

Aeroflex Signal & Control Solutions

www.aeroflex.com/ASCS • acc-sales@aeroflex.com

Revision Date: 8/21/2013

Specifications (con’t):

Output Phase Noise:

OFFSET

<250 MHz

.25 to

<.5 GHz

0.5 to

<1.0 GHz

1.0 to

<2.0 GHz

2.0 to

<4.0 GHz

4.0 to

<6.0 GHz

Typ.

Guar.

Typ.

Guar.

Typ.

Guar.

Typ.

Guar.

Typ.

Guar.

Typ.

Guar.

10 kHz

-125

-122

-135

-132

-131

-127

-125

-122

-119

-116

-113

-110

20 kHz

-127

-124

-137

-133

-133

-129

-127

-124

-121

-118

-115

-112

100

kHz

-128

-125

-138

-134

-134

-130

-128

-123

-122

-118

-116

-113

Harmonics

-25 dBc max.

4.5 to 6010 MHz

Sub Harmonics:

-60 dBc, Typical

-50 dBc Max except for components at FC noted below

@ FC=4.0 to 4.25, 5F/2 may be -45 dBc

@ Offsets ≤±2.8 MHz from the carrier, spurs will be as follows:

FC <180 MHz:

-60 dBc

180 MHz<FC<1.0 GHz

-66 dBc

1.0 GHz<FC<2.0 GHz

-60 dBc

2.0 GHz<FC<4.0 GHz

-54 dBc

4.0 GHz<FC<6.01 GHz

-48 dBc

For 1.0 GHz<FC <2 GHz, fixed spurs at the following frequencies may

be -60 dBc: 1175, 1225, 1275, 1325, 1375, 1425, 1475, 1525,

1575 and 1625 MHz

Spurious:

dBc (maximum)

Frequency Range

-65

4 to 2000 MHz

-60

2000 to 4000 MHz

-55

4000 to 6010MHz

For FC less than 180 MHz a spur may exist between 1609 Mz and

1960 MHz at -35 dBc: A fixed 800 MHz spur may exist at -60 dBc

all carrier frequencies

Residual FM:

Residual FM

Frequency Range

< 7

4 to 2000 MHz

<16

2000 to 4000 MHz

< 32

4000 to 6010MHz

Frequency Control:

Parallel BCD positive or negative true with strobe. Strobe normally

low, trigger on trailing edge

Output Fault:

TTL level logic, “1” normal operation

Remote On/Off (RF): O MHz = Off

On/Off Ratio

<25 dBc

Logic Connector:

50 Pin receptacle, AMP 554216-3

Initialization:

Unit will initialize with RF Off

Random Vibration:

10 Hz to 300 Hz @ 1.2 G RMS

Power:

105 to 125 VAC, 50-60 Hz

CONFIGURATION

S = Single Synthesizer

D = Dual, Two independent synthesizers in a common chassis

FS1000 Series

Fast Switching Synthesizer

Physical Dimensions:

Dimensions:

16.75” W X 5.22” H X 23.86” D