TUSB321AI datasheet(13/21 Pages) TI1

13 / 21 page

TUSB321AI

www.ti.com

SLLSER2 – OCTOBER 2015

Typical Application (continued)

8.2.1.1 Design Requirements

For this design example, use the parameters listed in Table 4:

Table 4. Design Requirements for DFP Mode

DESIGN PARAMETER

VALUE

VDD (4.5 V to 5.5 V)

5 V

DFP

Type-C port type (UFP, DFP, or DRP)

PORT pin is pulled up

Advertised Type-C Current (Default, 1.5 A, 3 A)

3 A

VCONN Support

Yes

8.2.1.2 Detailed Design Procedure

The TUSB321AI device supports a VDD in the range of 4.5 to 5.5 V. In this particular case, VDD is set to 5 V. A

100-nF capacitor is placed near VDD. Also, a 100 µF is used to meet the USB Type-C bulk capacitance

requirement of 10 µF to 220 µF.

The TUSB321AI current advertisement is determined by the state of the CURRENT_MODE pin. In this particular

example, 3 A advertisement is desired so the CURRENT_MODE pin is pulled high to VDD through 10-kΩ resistor.

The DIR pin is used to control the MUX for connecting the USB3 SS signals to the appropriate pins on the USB

Type-C receptacle. In this particular case, a HD3SS3212 is used as the MUX. In order to minimize crossing in

routing the USB 3.1 SS signals to the USB Type C connector, the connection of CC1 and CC2 to the

TUSB321AI is swapped.

The Type-C port mode is determined by the state of the PORT pin. When the PORT pin is pulled high, the

TUSB321AI device is in DFP mode.

The VBUS_DET pin must be connected through a 900-k

Ω resistor to VBUS on the Type-C that is connected. This

large resistor is required to protect the TUSB321AI device from large VBUS voltage that is possible in present day

systems. This resistor along with internal pulldown keeps the voltage observed by the TUSB321AI device in the

recommended range.

The USB3.1 specification requires the bulk capacitance on VBUS based on UFP or DFP. When operating the

TUSB321AI device in a DFP mode, a bulk capacitance of at least 120 µF is required. In this particular case, a

150-µF capacitor was chosen.

8.2.1.3 Application Curve

Figure 4. Application Curve for DFP Mode

Submit Documentation Feedback

Product Folder Links: TUSB321AI

TUSB321AI 数据表(PDF) 13 Page - Texas Instruments

TUSB321AI 数据表(HTML) 13 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21

数据表下载