| 数据搜索系统,热门电子元器件搜索 |
|
CLC030VEC 数据表(PDF) 21 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
CLC030VEC 数据表(HTML) 21 Page - National Semiconductor (TI) |
|
21 / 29 page ![]() Device Operation (Continued) out-of-band frequency products which can be produced by abrupt transitions in the chroma and luma data when fed to D-to-A converters and picture monitors. The default condi- tion of this bit is reset (off). I/O PIN 0 THROUGH 7 CONFIGURATION REGISTERS (Addresses 0Fh through 16h) The Multi-function I/O Bus Pin Configuration registers are used to map the bits of the multi-function I/O port to selected bits of the Configuration and Control Registers. Table 6 details the available Configuration and Control register bit functions that may be mapped to the port and their corre- sponding mapping addresses. Pin # SEL[5] in each register indicates whether the port pin is input or output. The port pin will be an input when this bit is set and an output when reset. Input-only functions may not be configured as outputs and vice versa. The remaining lower-order five address bits dis- tinguish the particular function. Example: Program, via the AD port, I/O port bit 0 as output for the CRC Luma Error bit in the control registers. 1. Set ANC/CTRL to a logic-low. 2. Set RD/WR to a logic-low. 3. Present 00Fh to AD[9:0] as the I/O PIN 0 CONFIG register address. 4. Toggle ACLK. 5. Present 310h to AD[9:0] as the register data, the bit address of the CRC Luma Error bit in the control regis- ters. 6. Toggle ACLK. TEST MODE 0 REGISTER (Address 55h) The four bits of this register are intended for use as test mode functions. They are not normal operating modes. The bits may be set (enabled) or reset (disabled) by writing to the register. Reading this register sets (enables) all bits to their default ON condition. The Scrambler_Enable bit enables operation of the SMPTE scrambler function. This bit is normally ON. The NRZI_Enable bit enables operation of the NRZ-to-NRZI conversion function. This bit is normally ON. The LSB_Clipping bit enables operation of the LSB clipping function. This bit is normally ON. The Sync_Detect_Enable bit enables operation of the TRS detector function. This bit is normally ON. www.national.com 21 |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |