COP884CF datasheet(13/44 Pages) NSC

13 / 44 page

Typical Performance Characteristics (−40˚C to +85˚C) (Continued)

Pin Descriptions

CC and GND are the power supply pins.

REF and AGND are the reference voltage pins for the

on-board A/D converter.

CKI is the clock input. This can come from an R/C generated

oscillator, or a crystal oscillator (in conjunction with CKO).

See Oscillator Description section.

RESET is the master reset input. See Reset Description sec-

tion.

The device contains three bidirectional 8-bit I/O ports (C, G

and L), where each individual bit may be independently con-

figured as an input (Schmitt trigger inputs on ports G and L),

output or TRI-STATE under program control. Three data

memory address locations are allocated for each of these

I/O ports. Each I/O port has two associated 8-bit memory

mapped registers, the CONFIGURATION register and the

output DATA register. A memory mapped address is also re-

served for the input pins of each I/O port. (See the memory

map for the various addresses associated with the I/O ports.)

Figure 4 shows the I/O port configurations. The DATA and

CONFIGURATION registers allow for each port bit to be in-

dividually configured under software control as shown below:

CONFIGURA-

TION

DATA

Port Set-Up

Hi-Z Input

(TRI-STATE Output)

Input with Weak Pull-Up

Push-Pull Zero Output

Push-Pull One Output

PORT L is an 8-bit I/O port. All L-pins have Schmitt triggers

on the inputs.

Port L supports Multi-Input Wakeup (MIWU) on all eight pins.

L4 and L5 are used for the timer input functions T2A and

T2B. L0 and L1 are not available on the 44-pin version of the

device, since they are replaced by V

REF and AGND. L0 and

L1 are not terminated on the 44-pin version. Consequently,

reading L0 or L1 as inputs will return unreliable data with the

44-pin package, so this data should be masked out with user

software when the L port is read for input data. It is recom-

mended that the pins be configured as outputs.

Port L has the following alternate features:

MIWU

MIWU or T2B

MIWU or T2A

MIWU

Port D Source Current

DS009425-35

Port D Sink Current

DS009425-36

DS009425-6

FIGURE 4. I/O Port Configurations

COP884CF 数据表(PDF) 13 Page - National Semiconductor (TI)

COP884CF 数据表(HTML) 13 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

数据表下载