0.000

0.097 (2.46)

0.697 (17.70)

Squared corner and dot on

top of case indicate pin one.

0.397 (10.08)

Projection Weld

Seam Seal

1

3

8

4

7

2

6 5

BOTTOM VIEW CASE A1

0.018 ± 0.002 dia.

(0.46 ± 0.05)

Seal hole: 0.056 ±0.002 (1.42 ±0.05)

Case dimensions in inches (mm)

Tolerance ±0.005 (0.13) for three decimal places

±0.01 (0.3) for two decimal places

unless otherwise specified

CAUTION

Heat from reflow or wave soldering may damage the device.

Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin

Materials

Header

Kovar/Nickel/Gold

Cover

Kovar/Nickel

Pins

Kovar/Nickel/Gold matched glass seal

Case A1, Rev C, 20060110

Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,

but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make

changes in products or specifications without notice.

Copyright © 1999-2006 Interpoint Corp. All rights reserved.

0.805 max. (20.45)

Crane Aerospace & Electronics Power Solutions

Page 7 of 10

RevA-20070509

STF28-461 EMI Input Filter Cases

28 VOlT INPuT – 0.8 aMP

www.craneae.com