MCP2003B-ESLASHMF datasheet(8/32 Pages) MICROCHIP

8 / 32 page

MCP2003B

DS20005463C-page 8

 2015-2016 Microchip Technology Inc.

1.5.4.1

TXD Dominant Timeout

If TXD is driven low for longer than approximately

25 ms, the LBUS pin is switched to Recessive mode and

the part enters TOFF Mode. This is to prevent the LIN

node from permanently driving the LIN Bus dominant.

The transmitter is reenabled on TXD rising edge.

1.5.5

GROUND (VSS)

This is the Ground pin.

1.5.6

LIN BUS (LBUS)

The bidirectional LIN Bus pin (LBUS) is controlled by the

TXD input. LBUS has a current limited open collector

output. To reduce EMI, the edges during the signal

changes are slope controlled and include corner

rounding control for both falling and rising edges.

The internal LIN receiver observes the activities on the

LIN bus, and matches the output signal RXD to follow

the state of the LBUS pin.

1.5.6.1

Bus Dominant Timer

The Bus Dominant Timer is an internal timer that

deactivates the LBUS transmitter after approximately

25 ms of dominant state on the LBUS pin. The timer is

reset on any recessive LBUS state.

The LIN bus transmitter will be reenabled after a

recessive state on the LBUS pin as long as CS is high.

Disabling can be caused by the LIN bus being

externally held dominant, or by TXD being driven low.

1.5.7

BATTERY (VBB)

This is the Battery Positive Supply Voltage pin.

1.5.8

VOLTAGE REGULATOR ENABLE

OUTPUT (VREN)

This is the External Voltage Regulator Enable pin.

Open-drain output is pulled high to VBB in all modes

except Power-Down.

1.5.9

EXPOSED THERMAL PAD (EP)

Do not electrically connect, or connect to VSS.

MCP2003B-E/MF 数据表(PDF) 8 Page - Microchip Technology

MCP2003B-E/MF 数据表(HTML) 8 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

数据表下载