OMAP3530ECBBA datasheet(154/265 Pages) TI1

154 / 265 page

Cycle(orPeriod)Jitter

Tn-1

Tn+1

Max.CycleJitter=Max(T )

Min.CycleJitter=Min(T )

JitterStandardDeviation(orrmsJitter)=StandardDeviation(T )

030-020

OMAP3530, OMAP3525

SPRS507H – FEBRUARY 2008 – REVISED OCTOBER 2013

www.ti.com

TIMING REQUIREMENTS AND SWITCHING CHARACTERISTICS

6.1

Timing Test Conditions

All timing requirements and switching characteristics are valid over the recommended operating conditions

of , unless otherwise specified.

6.2

Interface Clock Specifications

6.2.1

Interface Clock Terminology

The Interface clock is used at the system level to sequence the data and/or control transfers accordingly

with the interface protocol.

6.2.2

Interface Clock Frequency

The two interface clock characteristics are:

•

The maximum clock frequency

•

The maximum operating frequency

The interface clock frequency documented in this document is the maximum clock frequency, which

corresponds to the maximum frequency programmable on this output clock. This frequency defines the

maximum limit supported by the OMAP3530/25 IC and doesn’t take into account any system consideration

(PCB, peripherals).

The system designer will have to consider these system considerations and OMAP3530/25 IC timings

characteristics as well, to define properly the maximum operating frequency, which corresponds to the

maximum frequency supported to transfer the data on this interface.

6.2.3

Clock Jitter Specifications

Jitter is a phase noise, which may alter different characteristics of a clock signal. The jitter specified in this

document is the time difference between the typical cycle period and the actual cycle period affected by

noise sources on the clock. The cycle (or period) jitter terminology identifies this type of jitter.

Figure 6-1. Cycle (or Period) Jitter

6.2.4

Clock Duty Cycle Error

The duty cycle error is the ratio between either the high-level pulse duration or the low-level pulse duration

and the cycle time of a clock signal.

154

TIMING REQUIREMENTS AND SWITCHING CHARACTERISTICS

Submit Documentation Feedback

Product Folder Links: OMAP3530 OMAP3525

OMAP3530ECBBA 数据表(PDF) 154 Page - Texas Instruments

OMAP3530ECBBA 数据表(HTML) 154 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载