11

DF60 Series

BPrecautionary notes

1.Recommended soldering

conditions

■ Soldering profile when using an automatic soldering device

Soldering temperature: 260

℃ ; Soldering time: no more than 10 seconds

■ Hand soldering conditions

Temperature of soldering iron: 350±10

℃ , soldering time: no more than 3 seconds

2. Cleaning Conditions

Please refer to the "Wire-to-Board Connector Guide".

Cleaning with IPA is allowed. (Other cleaning agents are not recommended due to the

fact that it may change the push/pull feeling. Please contact us when you use other

cleaning agents. )

3. Wiring condition

Please refer to the "Wire-to-Board Connector Guide" and "DF60 Harness procedure".

 

4. Important notes

■ Caution is required for mating and un-mating the connector without it being mounting

on a PCB. Doing so can damage or deform the contacts.

■ During hand soldering, do not apply excess amounts flux which can migrate on to the

connector.

■ This product may have a slight differences in color depending on the production lot.

This difference does not have any influence on the performance.

■ Please refer to "DF60 Harness procedure" for the handling precautions during mating

and un-mating operations.

5. Handling instructions

Please refer to the "Wire-to-Board Connector Guide”.

6. Right angle pin header

 Precautions for use

Since the lead mounting part has some exposed parts,

please insure sufficient clearance when mounting other

parts near this connector.

7. In-line connector

Panel fixing operation

① Insert a M3 nut from the lateral direction.

②Push the nut in the direction of the arrow.

③Nut insertion is then complete.

④Panel mounting is completed by installing a

connector on the panel cutout hole and

tightening wit a M3 screw. Torque value is

49N·cm max.

Lead part