CT10.241

C-Series

Output protection

Output over-voltage protection

typ. 30.5Vdc

max. 32Vdc

In case of an internal power supply defect, a redundant

circuit limits the maximum output voltage. The output

shuts down and automatically attempts to restart.

Degree of protection

IP 20

EN/IEC 60529

Penetration protection

> 3.5mm

e.g. screws, small parts

Over-temperature protection

yes

output shut-down with automatic restart

Input transient protection

MOV (Metal Oxide Varistor) and active transient filter

Internal input fuse

3x T3.15A H.B.C.

not user replaceable

*)

In case of a protection event, audible noise may occur.

SELV

IEC/EN 60950-1

PELV

IEC/EN 60204-1, EN 50178, IEC 62103, IEC 60364-4-41

Class of protection

I

PE (Protective Earth) connection required

Isolation resistance

> 5MOhm

input to output, 500Vdc

PE resistance

< 0.1Ohm

Touch current (leakage current)

typ. 0.17mA

3x 400Vac, 50Hz, TN mains

typ. 0.24mA

3x 480Vac, 60Hz, TN mains

< 0.22mA

3x 440Vac, 50Hz, TN mains

< 0.31mA

3x 528Vac, 60Hz, TN mains

*)

Double or reinforced insulation

The output voltage is floating and has no ohmic connection to the ground. Type and factory tests are conducted by

the manufacturer. Field tests may be conducted in the field using the appropriate test equipment which applies the

voltage with a slow ramp (2s up and 2s down). Connect all phase-terminals together as well as all output poles before

conducting the test. When testing, set the cut-off current settings to the value in the table below.

Fig. 17-1 Dielectric strength

A

B

C

Type test

60s

2500Vac

3000Vac

500Vac

Factory test

5s

2500Vac

2500Vac

500Vac

Field test

5s

2000Vac

2000Vac

500Vac

Cut-off current setting

> 10mA

> 10mA

> 30mA

A

C

B

L1

Input

Earth

Output

-

+

L3

L2

To fulfill the PELV requirements according to EN60204-1 § 6.4.1, we

recommend that either the + pole, the – pole or any other part of

the output circuit shall be connected to the protective earth

system. This helps to avoid situations in which a load starts

unexpectedly or can not be switched off when unnoticed earth

faults occur.

Jan. 2010 / Rev. 1.3 DS-CT10.241-EN

All parameters are specified at 24V, 10A, 3x400Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

13/22