This document is proprietary. Any dispatch or disclosure of content is authorized only after written authorization by PULS GmbH.

All parameters are specified at 400V, 2.5A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

Specification: SP-PAS395 Rev: 3.1

Date: 2013/01/19

8-14

8

LEDs and Relay Contacts Pattern

Input-OK

LED

Output-OK

LED

Fully charged

LED

Output OK

Fully charged

Contact

Capacitors in charging mode

ON

ON

OFF

closed

open

Capacitors fully charged

ON

ON

ON

closed

closed

Inhibit input activated

ON

OFF

OFF ***)

open

open***)

Capacitor does not permit charging

(e.g. short circuit across output)

ON

typ. ON 130s

OFF110s…

OFF

typ. ON 130s

OFF110s…

open

No capacitor connected

ON

ON

ON

closed

closed

Over-temperature shut-down (OTP)

ON

OFF

according to the

state-of-charge

open

according to the

state of charge

Over-voltage protection activated (OVP)

ON

OFF **)

flashing

open **)

closed

Input voltage < 150V

OFF

OFF

OFF

open

open

*)

The Output-OK contact is synchronized with the Output-OK Led.

**)

Short single pulses will be suppressed in order to avoid a false triggering of the OVP.

***) delayed by a couple of seconds

9

Environment

Operational Temp. Range: -40°C to +65°C

Storage Temp. Range:

-55°C to +85°C

Humidity:

10 – 90% r.H.

Do not energize while condensation is present

Altitude:

0 to 6000m above sea level

Overvoltage Category

III up to 2000m altitude

II up to 6000m altitude

according to IEC 62103, EN 50178

Degree of pollution

2 (IEC 62103, EN 50178, not conductive)

Shock

According to IEC 60068-2-27

20g 11ms, 3 bumps / direction, 18 bumps in total

30g 6ms, 3 bumps / direction, 18 bumps in total

Vibration sinusoidal

According to IEC 60068-2-6

2-17.8Hz: ±1.6mm; 17.8-500Hz: 2g, 2 hours / axis

Vibration random

According to IEC 60068-2-64

10-500Hz: 0.5 m²/s³

Test duration: 120 minutes