GAMEWELL-FCI

12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118

Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.

©2013 by Honeywell International Inc. All rights reserved.

www.gamewell-fci.com

9021-60293 Rev. C page 1 of 2

Flex Series

GF505 and GF510

5 and 10 Zone Conventional

Fire Alarm Control Panels

Reference Certificate

of Compliance

VMA-45894-02C

(Revision 1)

SIGNALING

S1869

APPROVED

FM

MEA

Approve

d

7165-1703:0166

Description

UL® is a registered trademark of Underwriter’s Laboratories Inc.

The Flex 505 is a five zone fire alarm control panel (FACP)

and the Flex 510 is a ten zone FACP. These combination

control and digital communicator panels provide reliable

fire signaling protection for medium sized commercial,

industrial and institutional buildings.

Initiating device circuits (IDCs) for Flex Series panels are

programmable and operate in Class B (Style B). Each

panel is compatible with conventional input devices such

as two-wire smoke detectors, four-wire smoke detectors,

pull stations, water flow devices, tamper switches and

other normally-open contact devices. This includes System

advanced features like drift compensation, maintenance

alert and freeze warning. (See the Gamewell-FCI Device

Compatibility Document, P/N 52195, for a listing of com-

patible devices).

Outputs include four notification appliance circuits (NACs),

three programmable Form-C relays (factory pre-set for

Alarm, Trouble and Supervisory), and resettable and non

resettable power (24 VDC) for special applications. NACs

are power limited and operate in Class B (Style Y). The

FACP supervises wiring, AC voltage and battery level.

A variety of optional devices can be connected to the built-

in ANN-BUS 4-conductor communication circuit. These

include: remote annunciators, a printer interface module,

LED driver module, and relay module.

Activation of a compatible smoke detector or any normally-

open fire alarm initiating device will activate audible and

visual signaling devices, illuminate an indicating LED, dis-

play message on LCD display, sound the piezo sounder at

the FACP, activate the FACP alarm relay and operate and

optional modules used to notify a remote station or initiate

an auxiliary control function.

Both the Flex 505 and Flex 510 fire alarm control panel are

Features

•

IBC Seismic Certified.

•

Class B (Style B) initiating device circuits (IDCs):

- Flex 505 - five programmable IDCs

- Flex 510 - ten programmable IDCs

•

Built-in digital alarm communicator/transmitter (DACT).

•

Four Class B (Style Y) notification appliance circuits

(NACs) programmable for the following:

- ADA compliant strobe synchronization

- Selective silence (horn/strobe mute)

- Temporal or steady signal

- Silenceable or non-silenceable

- Auto-silence and silence inhibit

•

Three programmable Form-C relays.

•

24 VDC special application power outputs (resettable

and non-resettable).

•

Optional Class A converter module for NACs and IDCs

(model CAC-5X).

•

Optional transmitter module for municipal box service

and reverse polarity (model 4XTMF).

•

Completely field programmable at keypad

- does not require special software or extra equipment

- two password protected programming levels

•

80-character, backlit, high-angle, LCD display.

continued on next page

GF510