Philips Semiconductors

LPC2119/LPC2129

Single-chip 16/32-bit microcontrollers

Product data

Rev. 03 — 22 December 2004

25 of 34

9397 750 13146

© Koninklijke Philips Electronics N.V. 2004. All rights reserved.

7.

Limiting values

[1]

The following applies to the Limiting values:

a) Stresses above those listed under Limiting values may cause permanent damage to the device.

This is a stress rating only and functional operation of the device at these or any conditions other

than those described in Section 8 “Static characteristics” and Section 9 “Dynamic characteristics”

of this specification is not implied.

b) This product includes circuitry specifically designed for the protection of its internal devices from

the damaging effects of excessive static charge. Nonetheless, it is suggested that conventional

precautions be taken to avoid applying greater than the rated maximum.

c) Parameters are valid over operating temperature range unless otherwise specified. All voltages

[2]

Including voltage on outputs in 3-state mode.

[3]

[4]

Not to exceed 4.6 V.

[5]

The peak current is limited to 25 times the corresponding maximum current.

[6]

Dependent on package type.

Table 9:

Limiting values

In accordance with the Absolute Maximum Rating System (IEC 60134).[1]

Symbol

Parameter

Conditions

Min

Max

Unit

Supply voltage, internal rail

−0.5

+2.5

V

Supply voltage, external rail

−0.5

+3.6

V

Analog 3.3 V pad supply voltage

−0.5

4.6

V

Analog input voltage on A/D related

pins

−0.5

5.1

V

DC input voltage, 5 V tolerant I/O

pins[2][3]

−0.5

6.0

V

DC input voltage, other I/O pins[2][4]

−0.5

I

DC supply current per supply pin[5]

-

100

mA

I

DC ground current per ground pin[5]

-

100

mA

Storage temperature[6]

−65

150

°C

P

Power dissipation (based on

package heat transfer, not device

power consumption)

1.5

-

W