| 数据搜索系统,热门电子元器件搜索 |
|
LPS225HB 数据表(PDF) 31 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
LPS225HB 数据表(HTML) 31 Page - STMicroelectronics |
|
31 / 47 page ![]() DocID030115 Rev 2 31/47 LPS225HB Register description 47 8 Register description The device contains a set of registers which are used to control its behavior and to retrieve pressure and temperature data. The register address, made up of 7 bits, is used to identify them and to read/write the data through the serial interface. 8.1 INTERRUPT_CFG (0Bh) Interrupt configuration Address: 0Bh (R/W) Reset: 00h Description: Interrupt differential configuration register. See DIFF_EN bit in CTRL_REG1 (10h) [7] AUTORIFP: Enable AutoRifP. Default value: 0 (0: normal mode; 1: AutoRifP enable); [6] RESET_ARP: Reset AutoRifP function. Default value: 0 [5] AUTOZERO: Enable Autozero. Default value: 0 (0: normal mode; 1: Autozero enable) [4] RESET_AZ: Reset Autozero function. Reset RIF_P reg. (address 15h, 16h, 17h), set pressure reference to default value RPDS reg (address 18h, 19h). Default value: 0 [3] DIFF_EN: Enable interrupt generation. Default value: 0 (0: interrupt generation disabled; 1: interrupt generation enabled) [2] LIR: Latch interrupt request to the INT_SOURCE (25h) register. Default value: 0 (0: interrupt request not latched; 1: interrupt request latched) [1] PLE: Enable interrupt generation on differential pressure low event. Default value: 0 (0: disable interrupt request; 1: enable interrupt request on measured differential pressure value lower than preset threshold) [0] PHE: Enable interrupt generation on differential pressure high event. Default value: 0 (0: disable interrupt request; 1: enable interrupt request on measured differential pressure value higher than preset threshold) AUTORIFP, when written to ‘1’, an internal register is set with current pressure values and the bit is forced to ‘0’. From that point on the content of the internal register is subtracted from the pressure output value and result is used for the interrupt generation. The output registers (PRESS_OUT_XL (28h), PRESS_OUT_L (29h), PRESS_OUT_H (2Ah)) are updated with the actual pressure value. The RESET_ARP bit is used to disable the AutoRifP function. RESET_ARP is self-cleared. 7 6 54321 0 AUTORIFP RESET_ARP AUTOZERO RESET_AZ DIFF_EN LIR PLE PHE |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |