ST1S14 datasheet(23/46 Pages) STMICROELECTRONICS

23 / 46 page

DocID17977 Rev 2

23/46

ST1S14

Application information

Ceramic capacitors:

If available for the required value and voltage rating, these capacitors usually have a

higher RMS current rating for a given physical dimension (due to very low ESR).

The drawback is the considerably high cost.

Tantalum capacitors:

Small tantalum capacitors with very low ESR are becoming more available. However,

they can occasionally burn if subjected to very high current during charge.

Therefore, it is suggested to avoid this type of capacitor for the input filter of the device

as they could be stressed by a high surge current when connected to the power supply.

If the selected capacitor is ceramic (so neglecting the ESR contribution), the input voltage

ripple can be calculated as:

Equation 20

7.1.2

Output capacitor

The output capacitor is very important to meet the output voltage ripple requirement.

Using a small inductor value is useful to reduce the size of the choke but it increases the

current ripple. So, to reduce the output voltage ripple, a low ESR capacitor is required.

Nevertheless, the ESR of the output capacitor introduces a zero in the open loop gain,

which helps to increase the phase margin of the system. If the zero goes to a very high

frequency, its effect is negligible.

Ceramic capacitors

Ceramic capacitors and very low ESR capacitors that introduce a zero outside the

designed bandwidth (fZ=1/(2*pi*ESR*COUT, see Section 6: Closing the loop) in general

should be avoided. A leading network across the upper resistor of the voltage divider is

useful to increase the phase margin and compensate the system (see Section 6.3:

Voltage divider). The effectiveness of the leading network increases at high output

voltage because the singularities become more split.

High ESR capacitors

The “high ESR capacitor” definition stands for a capacitor having an ESR value able to

introduce a zero into the designed system bandwidth, which can be, as a general rule,

up to fSW/5 at maximum. Tantalum or electrolytic capacitors belong to this group.

Equation 21

Table 8. List of ceramic capacitors for the ST1S14

Manufacturer

Series

Capacitor value (µ)

Rated voltage (V)

TAIYO YUDEN

UMK325BJ106MM-T

MURATA

GRM42-2 X7R 475K 50

4.7

IN PP

⋅

--------------------------

----

–

⎝⎠

⎛⎞

⋅

----

–

()

⋅

π ESR COUT

⋅⋅

⋅

----------------------------------------------------------

---------

ST1S14 数据表(PDF) 23 Page - STMicroelectronics

ST1S14 数据表(HTML) 23 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

数据表下载