Absolute maximum ratings and operating conditions

STCC2540

6/32

DocID024711 Rev 6

3

Absolute maximum ratings and operating conditions

Stressing the device beyond the rating listed in Table 2: Absolute maximum ratings (AMR)

may cause permanent damage to the device. These are stress ratings only and functional

operation of the device at these or any other conditions beyond those indicated in Table 3:

Operating conditions is not implied. Exposure to absolute maximum rating conditions for

extended periods may affect device reliability.

Table 2. Absolute maximum ratings (AMR)

Symbol

Parameter

Value

Unit

Supply voltage

-0.3 to 6.5

V

Logical input voltage

-0.3 to 6.5

Pull-up voltage (FAULT, CHARGING)

-0.3 to 6.5

Data switch pin voltage to ground

Data switch current, switch ON

±50

mA

Maximum power switch output current, power switch ON

Internally limited

-

25

mA

-55 to +150

°C

Lead solder temperature for 10 seconds temperature

260

60

°C/W

Maximum junction temperature (internally limited)

°C

IEC61000-4-2 contact discharge

(OUT, DP_IN, DM_IN pins)

8

kV

2

JEDEC machine model (all pins)

200

V

1. Reflow at temperature of 255 to 260 °C for time < 30 seconds (total thermal budget not to exceed

180 °C for a period from 90 to 150 seconds).

3. Measured in recommended application circuit with 1

μF ceramic capacitor + 150 μF low ESR electrolytic capacitor

connected between OUT and GND pins (see Figure 4: Typical application diagram).

Table 3. Operating conditions

Symbol

Parameter

Value

Unit

Supply voltage

4.5 to 5.5

V

Ambient operating temperature

-40 to +85

°C

Junction operating temperature

-40 to +125