ST72361AR4-Auto datasheet(39/279 Pages) STMICROELECTRONICS

39 / 279 page

ST72361xx-Auto

Supply, reset and clock management

Doc ID 12468 Rev 3

39/279

Supply, reset and clock management

5.1

Introduction

The device includes a range of utility features for securing the application in critical

situations (for example, in case of a power brown-out), and reducing the number of external

components. An overview is shown in Figure 11.

For more details, refer to dedicated parametric section.

5.2

Main features

●

Optional PLL for multiplying the frequency by 2

●

Reset Sequence Manager (RSM)

●

Multi-Oscillator Clock Management (MO)

–

4 Crystal/Ceramic resonator oscillators

●

System Integrity Management (SI)

–

Main supply Low voltage detection (LVD)

–

Auxiliary Voltage detector (AVD) with interrupt capability for monitoring the main

supply

5.3

Phase locked loop

If the clock frequency input to the PLL is in the range 2 to 4 MHz, the PLL can be used to

multiply the frequency by two to obtain an fOSC2 of 4 to 8 MHz. The PLL is enabled by option

byte. If the PLL is disabled, then fOSC2 =fOSC/2.

Caution:

The PLL is not recommended for applications where timing accuracy is required.

Section 20.5.2: PLL characteristics

Figure 10.

PLL block diagram

PLL OPTION BIT

PLL x 2

fOSC2

/ 2

fOSC

ST72361AR4-Auto 数据表(PDF) 39 Page - STMicroelectronics

ST72361AR4-Auto 数据表(HTML) 39 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载