Rev. 10

Rev. 10

February. 2011

February. 2011

www.acriche.com

www.acriche.com

31

Document No. : SSC-QP-7-07-24 (Rev.00)

•Storage

To avoid the moisture penetration, we recommend storing Z Power LEDs in a dry box

(or desiccator) with a desiccant . The recommended storage conditions are Temperature 5 to 30

degrees Centigrade. Humidity 50% maximum.

• Precaution after opening packaging

However LED is correspond SMD, when LED be soldered dip, interfacial separation may affect

the light transmission efficiency, causing the light intensity to drop.

Attention in followed.

a. Soldering should be done right after opening the package(within 24Hrs).

b. Keeping of a fraction

- Sealing

- Temperature : 5 ~ 40℃ Humidity : less than 30%

c. If the package has been opened more than 1week or the color of desiccant changes,

components should be dried for 10-12hr at 60±5℃

• Any mechanical force or any excess vibration shall not be accepted to apply during cooling

process to normal temp. after soldering.

• Please avoid rapid cooling after soldering.

• Components should not be mounted on warped direction of PCB.

• Anti radioactive ray design is not considered for the products listed here in.

• Gallium arsenide is used in some of the products listed in this publication. These products are

dangerous if they are burned or shredded in the process of disposal. It is also dangerous to

drink the liquid or inhale the gas generated by such products when chemically disposed.

• This device should not be used in any type of fluid such as water, oil, organic solvent and etc.

When washing is required, IPA(Isopropyl Alcohol) should be used.

• When the LEDs are illuminating, operating current should be decided after considering the

package maximum temperature.

• LEDs must be stored to maintain a clean atmosphere. If the LEDs are stored for 3 months or

more after being shipped from SSC, a sealed container with a nitrogen atmosphere should be used

for storage.

• The appearance and specifications of the product may be modified for improvement without

notice.

• Long time exposure of sunlight or occasional UV exposure will cause lens discoloration.

• The slug is connected to the anode. Therefore, we recommend to isolate the heat sink.

• Attaching LEDs, don’t use adhesives to generate organic vapor.

precaution for use