Rev. 10

Rev. 10

February. 2011

February. 2011

www.acriche.com

www.acriche.com

32

Document No. : SSC-QP-7-07-24 (Rev.00)

Z-Power LED is encapsulated by silicone resin for the highest flux efficiency.

Notes for handling of Silicone resin Z-Power LEDs

• Avoid touching silicone resin parts especially by sharp tools such as Pincette(Tweezers)

• Avoid leaving fingerprints on silicone resin parts.

• Dust sensitivity silicone resin need containers having cover for storage.

• When populating boards in SMT production, there are basically no restrictions

regarding the form of the pick and place nozzle, except that mechanical pressure on

the surface of the resin must be prevent.

• Please do not force over 2000 gf impact or pressure diagonally on the silicon lens.

It will cause fatal damage of this product

• Please do not recommend to cover the silicone resin of the LEDs with other resin

(epoxy, urethane, etc)

Handling of Silicone resin LEDs