CS61577 datasheet(18/44 Pages) ETC

18 / 44 page

the register. In either mode, a reset will set all reg-

isters to 0 and force the oscillator to its center

frequency before initiating calibration. A reset

will also set LOS high.

Power Supply

The device operates from a single +5 Volt supply.

Separate pins for transmit and receive supplies

provide internal isolation. These pins should be

connected externally near the device and decou-

pled to their respective grounds. TV+ must not

exceed RV+ by more than 0.3V.

Decoupling and filtering of the power supplies is

crucial for the proper operation of the analog cir-

cuits in both the transmit and receive paths. A 1.0

µF capacitor should be connected between TV+

and TGND, and a 0.1

µF capacitor should be con-

nected between RV+ and RGND. Use mylar or

ceramic capacitors and place them as closely as

possible to their respective power supply pins. A

µF tantalum capacitor should be added close

to the RV+/RGND supply. Wire-wrap bread-

boarding of the line interface is not recommended

because lead resistance and inductance serve to

defeat the function of the decoupling capacitors.

Schematic & Layout Review Service

Confirm Optimum

Schematic & Layout

Before Building Your Board.

For Our Free Review Service

Call Applications Engineering.

Call: (512) 445-7222

CS61577

DS155PP2

CS61577 数据表(PDF) 18 Page - List of Unclassifed Manufacturers