TSB41BA3IPFP datasheet(27/63 Pages) TI

27 / 63 page

TSB41BA3

IEEE 1394b THREEPORT CABLE TRANSCEIVER/ARBITER

SLLS155A − MAY 2003 − REVISED OCTOBER 2003

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

APPLICATION INFORMATION

designing with PowerPAD



The TSB41BA3 is housed in a high performance, thermally enhanced, 80-terminal PFP PowerPAD

 package.

Use of the PowerPAD package does not require any special considerations except to note that the PowerPAD,

which is an exposed die pad on the bottom of the device, is a metallic thermal and electrical conductor.

Therefore, if not implementing PowerPAD PCB features, the use of solder masks (or other assembly

techniques) may be required to prevent any inadvertent shorting by the exposed PowerPAD of connection

etches or vias under the package. The recommended option, however, is to not run any etches or signal vias

under the device, but to have only a grounded thermal land as explained below. Although the actual size of the

exposed die pad may vary, the maximum size required for the keepout area for the 80-terminal PFP PowerPAD

package is 10 mm

× 10 mm. The actual PowerPAD size for the TSB41BA3 is 6 mm × 6 mm.

It is recommended that there be a thermal land, which is an area of solder-tinned-copper, underneath the

PowerPAD package. The thermal land varies in size, depending on the PowerPAD package being used, the

PCB construction, and the amount of heat that needs to be removed. In addition, the thermal land may or may

not contain numerous thermal vias depending on PCB construction.

Other requirements for thermal lands and thermal vias are detailed in the TI application note PowerPAD



Thermally Enhanced Package Application Report, (SLMA002), available via the TI Web pages at URL:

http://www.ti.com.

Figure 9. Example of a Thermal Land for the TSB41BA3 PHY

For the TSB41BA3, this thermal land must be grounded to the low impedance ground plane of the device. This

improves not only thermal performance but also the electrical grounding of the device. It is also recommended

that the device ground terminal landing pads be connected directly to the grounded thermal land. The land size

ought to be as large as possible without shorting device signal terminals. The thermal land may be soldered

to the exposed PowerPAD using standard reflow soldering techniques.

While the thermal land may be electrically floated and configured to remove heat to an external heat sink, it is

recommended that the thermal land be connected to the low impedance ground plane for the device. More

information may be obtained from the TI application note PHY Layout, (SLLA020).

PowerPAD is a trademark of Texas Instruments.

TSB41BA3IPFP 数据表(PDF) 27 Page - Texas Instruments

TSB41BA3IPFP 数据表(HTML) 27 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

数据表下载