LTC4236

5

4236f

For more information www.linear.com/LTC4236

elecTrical characTerisTics

Note 1: Stresses beyond those listed under Absolute Maximum Ratings

may cause permanent damage to the device. Exposure to any Absolute

Maximum Rating condition for extended periods may affect device

reliability and lifetime.

Note 2: All currents into device pins are positive; all currents out of device

pins are negative. All voltages are referenced to GND unless otherwise

specified.

Note 3: An internal clamp limits the DGATE1 and CPO1 pins to a minimum

of 10V above and a diode below IN1. Driving these pins to voltages beyond

the clamp may damage the device.

Note 4: An internal clamp limits the DGATE2 and CPO2 pins to a minimum

of 10V above and a diode below D2SRC. Driving these pins to voltages

beyond the clamp may damage the device.

Note 5: An internal clamp limits the HGATE pin to a minimum of 10V

above and a diode below OUT. Driving this pin to voltages beyond the

clamp may damage the device.

Note 6: Thermal resistance is specified when the exposed pad is soldered

to a 3" x 5" , four layer, FR4 board.