GD25LE32DVJG datasheet(27/72 Pages) GIGADEVICE

27 / 72 page

1.8V Uniform Sector

Dual and Quad Serial Flash

GD25LE32D

Quad I/O Fast Read with

“8/16/32/64-Byte Wrap Around” in Standard SPI mode

The Quad I/O Fast Read command can be used to access a specific portion within a page by issuing

“Set Burst with

Wrap

” (77H) commands prior to EBH. The “Set Burst with Wrap” (77H) command can either enable or disable the “Wrap

Around

” feature for the following EBH commands. When “Wrap Around” is enabled, the data being accessed can be limited

to either an 8/16/32/64-byte section of a 256-byte page. The output data starts at the initial address specified in the

command, once it reaches the ending boundary of the 8/16/32/64-byte section, the output will wrap around the beginning

boundary automatically until CS# is pulled high to terminate the command.

The Burst with Wrap feature allows applications that use cache to quickly fetch a critical address and then fill the

cache afterwards within a fixed length (8/16/32/64-byte) of data without issuing multiple read commands. The

“Set Burst

with Wrap

” command allows three “Wrap Bits” W6-W4 to be set. The W4 bit is used to enable or disable the “Wrap Around”

operation while W6-W5 is used to specify the length of the wrap around section within a page.

Quad I/O Fast Read (EBH) in QPI mode

The Quad I/O Fast Read command is also supported in QPI mode. See Figure12b. In QPI mode, the number of

dummy clocks is configured by the

“Set Read Parameters (C0H)” command to accommodate a wide range application with

different needs for either maximum Fast Read frequency or minimum data access latency. Depending on the Read

Parameter Bits P[5:4] setting, the number of dummy clocks can be configured as either 4/6/8. In QPI mode, the

“Continuous Read Mode” bits M7-M0 are also considered as dummy clocks. “Continuous Read Mode” feature is also

available in QPI mode for Quad I/O Fast Read command.

“Wrap Around” feature is not available in QPI mode for Quad I/O

Fast Read command. To perform a read operation with fixed data length wrap around in QPI mode, a dedicated

“Burst

Read with Wrap

” (0CH) command must be used.



Figure12b. Quad I/O Fast Read Sequence Diagram (M5-4= (1, 0) QPI)

CS#

SCLK

IO0

IO1

IO2

IO3

Command

EBH

A23-16

A15-8

A7-0

M7-0*

12 13

IOs switch from

Input to output

dummy* Byte1

Byte2

*"Set Read Parameters"

Command (C0H) can

set the number of

dummy clocks

GD25LE32DVJG 数据表(PDF) 27 Page - GigaDevice Semiconductor (Beijing) Inc.

GD25LE32DVJG 数据表(HTML) 27 Page - GigaDevice Semiconductor (Beijing) Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72

数据表下载