GD25VE32CSMS datasheet(17/63 Pages) GIGADEVICE

17 / 63 page

Uniform Sector

Dual and Quad Serial Flash

GD25VE32C

Figure 4. Write Enable for Volatile Status Register Sequence Diagram

7.4. Read Status Register (RDSR) (05H or 35H or 15H)

The Read Status Register (RDSR) command is for reading the Status Register. The Status Register may be read at

any time, even while a Program, Erase or Write Status Register cycle is in progress. When one of these cycles is in progress,

it is recommended to check the Write in Progress (WIP) bit before sending a new command to the device. It is also possible

to read the Status Register continuously.

For command code “05H” / “35H” / “15H”, the SO will output Status Register bits

S7~S0 / S15-S8 / S16-S23.

Figure 5. Read Status Register Sequence Diagram

7.5. Write Status Register (WRSR) (01H or 31H or 11H)

The Write Status Register (WRSR) command allows new values to be written to the Status Register. Before it can be

accepted, a Write Enable (WREN) command must previously have been executed. After the Write Enable (WREN)

command has been decoded and executed, the device sets the Write Enable Latch (WEL).

The Write Status Register (WRSR) command has no effect on

S23, S20, S19, S18, S17, S16, S15, S10, S1 and

S0 of the Status Register. CS# must be driven high after the eighth bit of the data byte has been latched in. If not, the Write

Status Register (WRSR) command is not executed. As soon as CS# is driven high, the self-timed Write Status Register

cycle (whose duration is tW) is initiated. While the Write Status Register cycle is in progress, the Status Register may still

be read to check the value of the Write In Progress (WIP) bit. The Write In Progress (WIP) bit is 1 during the self-timed

Write Status Register cycle, and is 0 when it is completed. When the cycle is completed, the Write Enable Latch (WEL) is

reset.

The Write Status Register (WRSR) command allows the user to change the values of the Block Protect (BP4, BP3,

BP2, BP1, and BP0) bits, to define the size of the area that is to be treated as read-only, as defined in Table1. The Write

Status Register (WRSR) command also allows the user to set or reset the Status Register Protect (SRP1 and SRP0) bits

Command

05H or 35H or 15H

CS#

SCLK

High-Z

9 10 11 12 13 14 15

MSB

Register0/1/2

MSB

Register0/1/2

CS#

SCLK

Command(50H)

High-Z

GD25VE32CSMS 数据表(PDF) 17 Page - GigaDevice Semiconductor (Beijing) Inc.

GD25VE32CSMS 数据表(HTML) 17 Page - GigaDevice Semiconductor (Beijing) Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

数据表下载