RF2958PCBA datasheet(12/20 Pages) RFMD

12 / 20 page

11-274

RF2958

Rev A0 050209

SERIAL DATA INTERFACE

A three wire serial data interface allows user programming of the internal control registers in the RF2958. The serial data

interface consists of the serial select (SSB), serial data in (SDI) and serial clock (SCLK) pins. The SDI is a bi-directional

pin, by default it is configured as an input to the serial interface, but during a read session it is used as an output.

The first bit in a serial transfer (the MSB) is the read/write (R/W) bit. R/W = 1 for a read, and R/W = 0 for a write.

The figure below shows a timing diagram for a serial transfer to the RF2958 serial data interface. The serial select (SSB)

pin is normally high. A serial transfer is initiated by taking SSB low. The address and data bits on the serial data in (SDI)

pin are shifted in on rising edges of the serial clock (SCLK) pin, MSB first. The data is latched and changes take effect on

the falling edge of the clock pulse corresponding to the last (18th) data bit in the addressed register. If the transfer is inter-

rupted, such that the 18th data bit clock pulse does not occur, then no data is written to the register.

When the synthesizers are programmed, an internal pulse is generated alerting the synthesizer that a new setting is

required. In order to guarantee that this internal pulse is long enough, the time between the falling edge of the last serial

clock pulse and the rising edge of SSB must be at least 1/fr.

The RF2958 can be reset to its power on condition (including register defaults) by writing ‘011111b’ plus 18 don’t care

bits to the serial data interface. The reset is actually performed when the SSB is raised after the write. Although this com-

mand can be performed during any settings of the MODE0 and MODE1 pins, care should be taken to ensure that the

registers are reprogrammed in a sufficient time to perform any transmit or receive operations.

rw=1

addr4

addr3

addr1

addr0

data17

data16

data1

data0

Serial Write

Serial Read

sdi pin direction - input

sdi pin direction - output

addr4

addr3

addr1

addr0

data17

data16

data1

data0

rw=0

SSB

SDI

SCLK

SSB

SCLK

SDI

RF2958PCBA 数据表(PDF) 12 Page - RF Micro Devices

RF2958PCBA 数据表(HTML) 12 Page - RF Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

数据表下载