PCF2129AT datasheet(49/86 Pages) PHILIPS

49 / 86 page

PCF2129

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 7 — 19 December 2014

49 of 86

NXP Semiconductors

PCF2129

Accurate RTC with integrated quartz crystal for industrial applications

The signal applied to pin CLKOUT should have a minimum pulse width of 300 ns and a

maximum period of 1000 ns. The internal clock, now sourced from CLKOUT, is divided

down by a 26 divider chain called prescaler (see Table 73). The prescaler can be set into a

known state by using bit STOP. When bit STOP is logic 1, the prescaler is reset to 0.

STOP must be cleared before the prescaler can operate again.

From a stop condition, the first 1 second increment will take place after 32 positive edges

on pin CLKOUT. Thereafter, every 64 positive edges cause a 1 second increment.

Remark: Entry into test mode is not synchronized to the internal 64 Hz clock. When

entering the test mode, no assumption as to the state of the prescaler can be made.

Operating example:

1. Set EXT_TEST test mode (register Control_1, EXT_TEST is logic 1).

2. Set bit STOP (register Control_1, STOP is logic 1).

3. Set time registers to desired value.

4. Clear STOP (register Control_1, STOP is logic 0).

5. Apply 32 clock pulses to CLKOUT.

6. Read time registers to see the first change.

7. Apply 64 clock pulses to CLKOUT.

8. Read time registers to see the second change.

Repeat 7 and 8 for additional increments.

8.14 STOP bit function

The function of the STOP bit is to allow for accurate starting of the time circuits. STOP

causes the upper part of the prescaler (F9 to F14) to be held in reset and thus no 1 Hz ticks

are generated. The time circuits can then be set and will not increment until the STOP bit

is released. STOP doesn’t affect the CLKOUT signal but the output of the prescaler in the

range of 32 Hz to 1 Hz (see Figure 26).

The lower stages of the prescaler, F0 to F8, are not reset and because the I2C-bus and the

SPI-bus are asynchronous to the crystal oscillator, the accuracy of restarting the time

circuits is between 0 and one 64 Hz cycle (0.484375 s and 0.500000 s), see Table 73 and

Figure 27.

Fig 26. STOP bit functional diagram

PCF2129AT 数据表(PDF) 49 Page - NXP Semiconductors

PCF2129AT 数据表(HTML) 49 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86

数据表下载