UM1075 Rev 8

5/19

UM1075

Features

18

1

Features

•

5 V power supplied by a USB connector

•

USB 2.0 full speed compatible interface

•

USB standard A to Mini-B cable

•

SWIM specific features

–

1.65 V to 5.5 V application voltage supported on SWIM interface

–

SWIM low-speed and high-speed modes supported

–

SWIM programming-speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in

high speed

–

SWIM cable for connection to the application via an ERNI standard vertical (ref:

284697 or 214017) or horizontal (ref: 214012) connector

–

SWIM cable for connection to the application via a pin header or a 2.54 mm pitch

connector

•

JTAG/serial wire debugging (SWD) specific features

–

1.65 V to 3.6 V application voltage supported on the JTAG/SWD interface and 5 V

tolerant inputs

–

JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector

–

Supports JTAG communication

–

Supports serial wire debug (SWD) and serial wire viewer (SWV) communication

•

Direct firmware update feature supported (DFU)

•

Status LED, which blinks during communication with the PC

•

•

Operating temperature from 0 to 50 °C

2

Ordering information

To order the ST-LINK/V2 refer to Table 1.

Table 1. List of the order codes

Order code

ST-LINK description

ST-LINK/V2

In-circuit debugger/programmer

ST-LINK/V2-ISOL

In-circuit debugger/programmer with digital isolation