MWCT1014SFVLLPR datasheet(63/65 Pages) NXP

63 / 65 page

Table 35. Revision History

Rev. No.

Date

Substantial Changes

• VLPS → VLPR

• RUN → VLPS

• RUN → VLPR

• In Power consumption :

• Updated specs

• Removed section 'Modes configuration', amd moved its

content under the fisrt paragraph.

• Updated footnote 'Typical current numbers are indicative ...'

• Updated footnote 'The MWCT1016S data ...'

• Removed footnote 'Above MWCT1016S data is preliminary

targets only'

• In General AC specifications :

• Updated max value and footnote of WFRST

• Updated symbol for not filtered pulse to 'WNFRST', updated

min value, removed max. value, and added footnote

• Fixed naming conventions to align with DS in DC electrical

specifications at 3.3 V Range and DC electrical specifications at 5.0

V Range

• Updated specs for AC electrical specifications at 3.3 V range and

AC electrical specifications at 5 V range

• In Device clock specifications :

• Added footnote to fBUS

• In External System Oscillator frequency specifications :

• Updated 'tdc_extal'

• Added footnote 'Frequecies below ... ' to 'fec_extal' and 'tdc_extal'

• Updated Flash timing specifications — commands

• In Reliability specifications :

• Updated footnotes

• In QuadSPI AC specifications :

• Updated 'MCR[SCLKCFG[5]]' value to 0

• Updated 'Data Input Setup Time' HSRUN Internal DQS PAD

Loopback value to 1.6

• Updated 'Data Input Setup Time' DDR External DQS min.

value to 2

• Updated 'Data Input Hold Time' DDR External DQS min. value

to 20

• Updated tIV

• Upadted figure 'QuadSPI output timing (SDR mode) diagram'

and 'QuadSPI input timing (HyperRAM mode) diagram'

• In 12-bit ADC operating conditions :

• Fixed the typo in RSW1

• Removed parameter '

ΔVDDA'

• In 12-bit ADC electrical characteristics :

• Added note 'On reduced pin packages where ... '

• Removed max. value of 'IDDA_ADC'

• Added note 'Due to triple ... '

• In CMP with 8-bit DAC electrical specifications :

• Updated Typ. and Max. values of 'IDDLS'

• Upadted Typ. value of 'tDHSB'

• Updated Typ. value of 'VHYST1' , 'VHYST2', and 'VHYST3'

• In LPSPI electrical specifications :

• Updated 'fperiph' and 'fop', and 'tSPSCK'

• Updated 3.3 V numbers and added footnote against fop, tSU,

ans tV in HSRUN Mode

• Added footnote to 'tWSPSCK'

Table continues on the next page...

Revision History

MWCT101XS Data Sheet, Rev. 3, 12/2019

NXP Semiconductors

MWCT1014SFVLLPR 数据表(PDF) 63 Page - NXP Semiconductors

MWCT1014SFVLLPR 数据表(HTML) 63 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65

数据表下载