ACE25AC200GL

2M SPI NOR FLASH

VER 1.2

8

Read Status Register (RDSR) (05H)

The Read Status Register (RDSR) command is for reading the Status Register. The Status Register may

be read at any time, even while a Program, Erase or Write Status Register cycle is in progress. When one

of these cycles is in progress, it is recommended to check the Write In Progress (WIP) bit before sending

a new command to the device. It is also possible to read the Status Register continuously.

Write Status Register (WRSR) (01H)

The Write Status Register (WRSR) command allows new values to be written to the Status Register.

Before it can be accepted, a Write Enable (WREN) command must previously have been executed. After

the Write Enable (WREN) command has been decoded and executed, the device sets the Write Enable

Latch (WEL).

The Write Status Register (WRSR) command has no effect on S6, S5, S1 and S0 of the Status Register.

CS# must be driven high after the eighth bit of the data byte has been latched in. If not, the Write Status

Register (WRSR) command is not executed. As soon as CS# is driven high, the self-timed Write Status

Register cycle (whose duration is tW) is initiated. While the Write Status Register cycle is in progress, the

Status Register may be read to check the value of the Write In Progress (WIP) bit. The Write In Progress

(WIP) bit is 1 during the self-timed Write Status Register cycle, and is 0 when it is completed. When the

cycle is completed, the Write Enable Latch (WEL) is reset.

The Write Status Register (WRSR) command allows the user to change the values of the Block Protect

(BP2, BP1, BP0) bits, to define the size of the area that is to be treated as read-only, as defined in

Table1.1 and 1.2. The Status Register Write Disable (SRWD) bit is a non-volatile One Time Program(OTP)

bit, the Write Status Register (WRSR) command allows the user to set the Status Register Write Disable

(SRWD) bit to 1. The Status Register Write Disable (SRWD) bit allow the device to be put in another

Software Protected Mode. Once the SRWD bit is set to 1, the Write Status Register (WRSR) command is

not executed, and the SRWD bit and Block Protect bits (BP2, BP1, BP0) are read only.

Figure3. Read Status Register Sequence Diagram

Figure4. Write Status Register Sequence Diagram