MODEL: R3-ND2

R3-ND2 SPECIFICATIONS

ES-8381 Rev.20 Page 1/7

https://www.m-system.co.jp/

Remote I/O R3 Series

DeviceNet INTERFACE MODULE

(for 32-point analog signals)

109

[4.29]

27.5 [1.08]

130

[5.12]

mm [inch]

MODEL: R3-ND2-[1][2]

ORDERING INFORMATION

• Code number: R3-ND2-[1][2]

Specify a code from below for each of [1] and [2].

(e.g. R3-ND2-R/CE/Q)

• Specify the specification for option code /Q

(e.g. /C01/SET)

[1] POWER INPUT

N: No power supply

AC Power

K3: 100 – 120 V AC

(Operational voltage range 85 - 132 V, 47 - 66 Hz) *

(CE not available)

L3: 200 – 240 V AC

(Operational voltage range 170 - 264 V, 47 - 66 Hz) *

(CE not available)

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.) *

* Not selectable for use with independent power modules or

network modules with the internal power input options.

[2] OPTIONS (multiple selections)

Standards & Approvals

blank: Without CE

/CE: CE marking

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q (multiple selections)

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-8353)

RELATED PRODUCTS

• EDS file

(downloadable at M-System’s web site.)

GENERAL SPECIFICATIONS

Connection

DeviceNet: Euro type connector terminal

Internal bus: Via the Installation Base

(model: R3-BSx)

Internal power: Via the Installation Base (model: R3-BSx)

Power input, RUN contact output: M3 separable screw

terminal (torque 0.5 N·m)

Screw terminal: Nickel-plated steel

Isolation: DeviceNet to internal bus or internal power to

power input to RUN contact output to FG

Input error data setting: Input value setting at input module

error with side DIP SW

Dual communication setting: Set with the side DIP switch

Data allocation setting: Set with the side DIP switch

■ RUN CONTACT OUTPUT

RUN contact: Turns ON when both MS and NS LEDs are

green (DeviceNet in normal communication).

Rated load: 250 V AC @ 0.5 A (cos ø = 1)

30 V DC @ 0.5 A (resistive load)

(Less than 50 V AC to conform with EU Directive)

Maximum switching voltage: 250 V AC or 30 V DC

Maximum switching power: 250 VA or 150 W

Minimum load: 1 V DC @ 1 mA

When driving an inductive load, external contact protection

and noise quenching recommended.