STE2007 datasheet(20/62 Pages) STMICROELECTRONICS

20 / 62 page

4 INTERFACE

STE2007

20/62

Figure 10. 4-lines SPI Commands Transfe

Figure 11. 4-lines SPI Video Data Write Cycle

4.2.1.1 Data/Command Transfer break

If the Host processor generates an break condition (!CS Line HIGH before having received Bit

D0) while transferring a Data byte to the Frame Memory or a Command identifier or a command

parameter, the not complete received byte is discarded, the communication is interrupted and

the interface is forced in reset state.

When !CS line becomes low again to start a new communication session STE2007 is ready to

receive the same byte interrupted re-transmitted or a new command identifier.

Figure 12. 4-lines SPI Data Transfer break condition

4.2.1.2 Data/Command Transfer pause

It is possible while transferring Frame Memory Data, Commands or Command Parameters to

insert a pause in the data transmission (!CS Line HIGH after 8 Bits Received). When !CS is

forced high after a whole byte received, the received byte is processed. Then STE2007 is

forced in a wait state ready to restart processing incoming data from the point where the

communication has been paused

LR0189

Hi-Z

COMMAND

D/!C

!CS

SDA

(input)

SCL

SDA

(output)

LR0190

Hi-Z

COMMAND

DATA to VIDEO RAM

D/!C

!CS

SDA

(input)

SCL

SDA

(output)

DATA to VIDEO RAM

D/!C

!CS

SDA

SCL

LR0192

COMMAND/PARAMETER

Break

STE2007 数据表(PDF) 20 Page - STMicroelectronics

STE2007 数据表(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

数据表下载

链接网址

STE2007 数据表(PDF) 20 Page - STMicroelectronics

STE2007 数据表(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

数据表 下载

链接网址

数据表下载