ST25TV02K datasheet(32/90 Pages) STMICROELECTRONICS

32 / 90 page

•

Lock DSFID, used to lock the DSFID register.

•

Get System information, used to provide the standard system information values.

•

Write Password, used to update the 32 or 64 bit of the selected areas or configuration password, but only

after presenting the current one.

•

Lock Block, used to lock any user blocks.

•

Present Password, enables the user to present a password to open a security session.

•

Fast Read Single Block, used to output the 32 bits of the selected block and its locking status at doubled

data rate.

•

Fast Read Multiple Blocks, used to output the selected blocks in one or multiple areas providing the

access rights are granted at doubled data rate.

•

Get multiple block security status, used to send the security status of the selected block.

•

Initiate, used to trigger the tag response to the Inventory Initiated sequence.

•

Inventory Initiated, used to perform the anti-collision sequence triggered by the Initiate command.

•

Fast Initiate, used to trigger the tag response to the Fast Inventory Initiated sequence (fast commands are

with higher data rate).

•

Fast Inventory Initiated, used to perform the anti-collision sequence triggered by the Fast Initiate

command.

•

Inventory read performs anti-collision sequence then output selected blocks

•

Fast Inventory read performs inventory command then execute a read with data returned at doubled data

rate.

•

Lock Kill, used to lock the Kill or untraceable mode password.

•

Kill, used to definitively deactivate the tag.

•

Set EAS, activates the EAS feature if the EAS feature is not locked. (Not protected by password or locked)

•

Reset EAS, deactivates the EAS feature if the EAS feature is not locked. (not protected by password or

locked)

•

Enable EAS, ST25TV02K/512 answer to this command only if EAS state is set. Response will include the

EAS Telegram (32 up to 256 bits depending on the EAS config)

•

Write EAS ID writes a new EAS identifier Number. (Protected by configuration password).

•

Write EAS CONFIG, used to configure the EAS telegram data length with 2bits 00 = 256 bits 01= 128 bits

10 = 64 bits 11= 32 bits (protected by configuration password).

•

Lock EAS will lock EAS mode: (reset / set) and EAS ID and the EAS Telegram.

•

Read Configuration used to read the counter values, the tamper detect status, and the number of Area.

•

Write Configuration allows to enable the counter configuration, clear counter, set number of Area (1 or 2)

and their access rights, and lock the configuration block.

•

Set Untraceable mode: sets the untraceable mode.

•

Get Random Number: generates a 16 bit number.

ST25TV02K ST25TV512

RF commands

DS12074 - Rev 11

page 32/90

ST25TV02K 数据表(PDF) 32 Page - STMicroelectronics

ST25TV02K 数据表(HTML) 32 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

数据表下载