User Manual

13 of 33

Revision 1.6

2018-11-27

EVAL-M1-101T User Manual

iMOTION™ Modular Application Design Kit

Getting Started with EVAL-M1-101T

4.2

iMOTION™ development tools and software

The iMOTION™Development Tool installers for MCEDesigner and MCEWizard are available for download via

variants are listed there. Please visit this page periodically to check for tool/software updates.

Isolated on-board debugger provides the USB to UART brigde between the PC and the target iMOTION™ device

with 1kV DC galvanic isolation between the motor drive system (hot side) and the PC/debugger (cold) side. On-

board debugger uses the SEGGER J-Link driver for UART communication with IMC101T-T038. J-Link driver will

be installed during the MCEDesigner installation. In case the driver is not installed properly, please go to

SEGGER J-Link website to download and install the latest J-Link “Software and Documentation pack for

Windows”.

4.2.1

MCEWizard setup overview

After installing the MCEWizard, the shortcut for MCEWizard appears on the Windows desktop. Double click the

shortcut to open the MCEWizard and configure the parameters for evaluation boards or motor. Figure 6 shows

the “Welcome Page” for MCEWizard, where the MADK control board or power board can be selected through

the pull-down list. Infineon keeps releasing new MADK controller and power boards. Therefore, it could happen

that some of the newest power boards are not pre-configured in the MCEWizard tool and cannot be selected

through the pull-down menu. In that case, the user should select any other power board (as similar as possible)

and follow the MCEWizard setup steps by entering the parameter values which are specific to the chosen board.

Make sure both “I have modified the circuit board” and “Enable advanced question” checkmarks are selected.

Please refer to the Application Note of the corresponding power board for additional information.

After selecting the MADK control and the power board, start the MCEWizard system setup procedure by clicking

the “Next” button in the right bottom corner as shown in Figure 6.

Figure 6

Welcome Page of MCEWizard