CC2430-RTR1-F32 datasheet(64/234 Pages) TI

64 / 234 page

CC2430

CC2430 PRELIMINARY Data Sheet (rev. 1.03) SWRS036A

Page 64 of 232

Command

Instruction code

Description

CHIP_ERASE

0001 0x00

Perform flash chip erase (mass erase) and clear lock bits. If any other

command, except READ_STATUS, is issued, then the use of

CHIP_ERASE is disabled.

WR_CONFIG

0001 1x01

Write configuration data. Refer to Table 34

RD_CONFIG

0010 0100

Read configuration data. Returns value set by WR_CONFIG command.

GET_PC

0010 1000

Return value of 16-bit program counter. Returns 2 bytes regardless of

value of bit 2 in instruction code

READ_STATUS

0011 0x00

Read status byte. Refer to Table 35

SET_HW_BRKPNT

0011 1x11

Set hardware breakpoint

HALT

0100 0100

Halt CPU operation

RESUME

0100 1100

Resume CPU operation. The CPU must be in halted state for this

command to be run.

DEBUG_INSTR

0101 01xx

Run debug instruction. The supplied instruction will be executed by the

CPU without incrementing the program counter. The CPU must be in

halted state for this command to be run.

STEP_INSTR

0101 1100

Step CPU instruction. The CPU will execute the next instruction from

program memory and increment the program counter after execution.

The CPU must be in halted state for this command to be run.

STEP_REPLACE

0110 01xx

Step and replace CPU instruction. The supplied instruction will be

executed by the CPU instead of the next instruction in program memory.

The program counter will be incremented after execution. The CPU must

be in halted state for this command to be run.

GET_CHIP_ID

0110 1000

Return value of 16-bit chip ID and version number. Returns 2 bytes

regardless of value of bit 2 of instruction code

Table 33: Debug Commands

Bit

Name

Description

7-4

Not used

Disable timers. Disable timer operation

0 Do not disable timers

timers_off

1 Disable timers

DMA pause

0 Enable DMA transfers

DMA_pause

1 Pause all DMA transfers

Suspend timers. Timer operation is suspended for debug

instructions and if a step instruction is a branch. If not

suspended these instructions would result an extra timer

count during the clock cycle in which the branch is

executed

0 Do not suspend timers

timer_suspend

1 Suspend timers

Select flash information page

0 Select flash main page

sel_flash_info_page

1 Select flash information page

Table 34: Debug Configuration

CC2430-RTR1-F32 数据表(PDF) 64 Page - Texas Instruments

CC2430-RTR1-F32 数据表(HTML) 64 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载