FDA803D datasheet(23/78 Pages) STMICROELECTRONICS

23 / 78 page

DocID031487 Rev 2

23/78

FDA803D

General information

6.1

LC filter design

The audio performance of a Class D amplifier are heavily influenced by the characteristics

of the output LC filter. The choice of its components is quite critical because a lot of

constraints have to be fulfilled at the same time: size, cost, filter for EMI suppression,

efficiency. In particular, both the inductor and the capacitor exhibit a non linear behavior: the

value of the inductance is a function of the instantaneous current in it and similarly the value

of the capacitor is a function of the voltage across it.

In the classical approach, where the feedback loop is closed right at the output of the power

stage, the LC filter is placed outside the loop and these nonlinearities cause the Total

Harmonic Distortion (THD) to increase. The only way to avoid this phenomenon would be to

use components which are highly linear, but this means they are also bigger and/or more

expensive.

Furthermore, when the LC filter is outside the loop, its frequency response heavily depends

on the impedance of the loudspeaker; this is one of the most critical aspects of Class-D

amplifiers. In standard class D this can be mitigated, but not solved, by means of additional

damping networks, increasing cost, space and power dissipation. FDA803D, instead,

provides a very flat frequency response over audio-band which can not be achieved by

standard class D without feedback after LC filter.

Since the demodulator group is now in the feedback path, some constraints regarding the

inductor and capacitor choice are still present but of course less stringent than in the case of

a typical switching application.

Moreover FDA803D can be used with the 'classical' configuration of feedback on output

(before LC filter), through I2C configuration, allowing the maximum flexibility. The choice

depends mainly on EMI target /requirements and could slightly affect other performances

(like damping factor, or THD).

6.2

Load possibilities

FDA803D supports several load possibilities, driving 2 Ω, 4 Ω and higher ohmic loads.

Possible channel configurations are:



1 x 4 ohm (or higher) (up to 18 V)



1 x 2 ohm (up to 16 V)

FDA803D 数据表(PDF) 23 Page - STMicroelectronics

FDA803D 数据表(HTML) 23 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78

数据表下载