STM32G0C1NET3XTR datasheet(20/159 Pages) STMICROELECTRONICS

20 / 159 page

Functional overview

STM32G0C1xC/xE

20/159

DS13564 Rev 4

HSI16 and LSI RC-oscillators and HSE crystal oscillator are also powered down. The

RTC can remain active (Shutdown mode with RTC, Shutdown mode without RTC).

The BOR is not available in Shutdown mode. No power voltage monitoring is possible

in this mode. Therefore, switching to RTC domain is not supported.

SRAM and register contents are lost except for registers in the RTC domain.

The device exits Shutdown mode upon external reset event (NRST pin), IWDG reset

event, wakeup event (WKUP pin, configurable rising or falling edge) or RTC event

(alarm, periodic wakeup, timestamp, tamper).

3.7.5

Reset mode

During and upon exiting reset, the schmitt triggers of I/Os are disabled so as to reduce

power consumption. In addition, when the reset source is internal, the built-in pull-up

resistor on NRST pin is deactivated.

3.7.6

VBAT operation

The VBAT power domain, consuming very little energy, includes RTC, and LSE oscillator and

backup registers.

In VBAT mode, the RTC domain is supplied from VBAT pin. The power source can be, for

example, an external battery or an external supercapacitor. Two anti-tamper detection pins

are available.

The RTC domain can also be supplied from VDD/VDDA pin.

By means of a built-in switch, an internal voltage supervisor allows automatic switching of

RTC domain powering between VDD and voltage from VBAT pin to ensure that the supply

voltage of the RTC domain (VBAT) remains within valid operating conditions. If both voltages

are valid, the RTC domain is supplied from VDD/VDDA pin.

An internal circuit for charging the battery on VBAT pin can be activated if the VDD voltage is

within a valid range.

Note:

External interrupts and RTC alarm/events cannot cause the microcontroller to exit the VBAT

mode, as in that mode the VDD is not within a valid range.

3.8

Interconnect of peripherals

Several peripherals have direct connections between them. This allows autonomous

communication between peripherals, saving CPU resources thus power supply

consumption. In addition, these hardware connections allow fast and predictable latency.

Depending on peripherals, these interconnections can operate in Run, Sleep and Stop

modes.

STM32G0C1NET3XTR 数据表(PDF) 20 Page - STMicroelectronics

STM32G0C1NET3XTR 数据表(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载