ELECTRONICS

FCI Electronics

Manual Part No. 415988-001

Issued: Date (03/12/99)

Page 10 of 18

Rev. 05/07/01 ECR V10337

Revision B

K\DCU\Manuals

PARTS REPLACEMENT PROCEDURE

Anvil Removal

NOTE: Replace anvils when they show excessive wear or become cracked or chipped.

1. Using a 3/32-inch Allen wrench loosen the attaching cap screw(s) for the defective anvil(s).

See Figure 6.

Figure 6

2. Using a 7/64-inch Allen wrench, remove the cap screw securing the anvil holder assembly to

the hand tool (see Figure 7). Then remove the anvil holder assembly.

Figure 7

3. Remove the cap screw(s) and defective anvil(s) from the anvil holder assembly (see Figure 8).

Figure 8

PDM: Rev:B

Released

STATUS:

Printed: Dec 19, 2002