ELECTRONICS

FCI Electronics

Manual Part No. 415988-001

Issued: Date (03/12/99)

Page 6 of 18

Rev. 05/07/01 ECR V10337

Revision B

K\DCU\Manuals

CAUTION

If the terminal and the tooling are not compatible, damage to the tooling could result. If you wish to use a

terminal with a part number other than the one that was ordered for the HT-0095, check with your distributor

or with FCI Electronics to be sure that the new terminal number is compatible with your hand tool.

OPERATION

Operating Procedures

WARNING

To prevent hand injury, keep fingers from between the upper and lower tooling and from

between the lever and handle when closing hand tool.

1. Hold the hand tool so that the lever is on the left. With your index finger, push and hold the

terminal holder in its forward position (see Figure 2).

2. Insert the disconnect (box) portion of the terminal, with "U" shaped barrels up, onto the holding

pin and against the pin shoulder. While holding the terminal against the shoulder, release the

terminal holder. This ensures that the terminal remains in proper position while moving over the

anvil.

Figure 2. Positioning Terminal

PDM: Rev:B

Released

STATUS:

Printed: Dec 19, 2002