AD8190ACPZ-R7 datasheet(4/24 Pages) AD

4 / 24 page

AD8190

Rev. 0 | Page 4 of 24

Parameter

Conditions/Comments

Min

Typ

Max

Unit

SERIAL CONTROL INTERFACE5

Input High Voltage, VIH

Input Low Voltage, VIL

0.8

Output High Voltage, VOH

2.4

Output Low Voltage, VOL

0.4

1 Differential interpair skew is measured between the TMDS pairs of a single link.

2 AD8190 output meets the transmitter eye diagram as defined in the DVI Standard Revision 1.0 and the HDMI Standard Revision 1.2a.

3 Cable output meets the receiver eye diagram mask as defined in the DVI Standard Revision 1.0 and the HDMI Standard Revision 1.2a.

4 Typical value assumes only the selected HDMI/DVI link is active with nominal signal swings and that the unselected HDMI/DVI link is deactivated. Minimum and

maximum limits are measured at the respective extremes of input termination resistance and input voltage swing.

5 The AD8190 is an I2C slave and its serial control interface is based on the 3.3 V I2C bus specification.

AD8190ACPZ-R7 数据表(PDF) 4 Page - Analog Devices

AD8190ACPZ-R7 数据表(HTML) 4 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

数据表下载