TSL27711 datasheet(39/51 Pages) OSRAM

39 / 51 page

Page 38

ams Datasheet

Document Feedback

[v1-00] 2016-Mar-22

TSL2771 − Application Information Hardware

LED Driver Pin with Proximity Detection

In a proximity sensing system, the IR LED can be pulsed by the

TSL2771 with more than 100 mA of rapidly switching current,

therefore, a few design considerations must be kept in mind to

get the best performance. The key goal is to reduce the power

supply noise coupled back into the device during the LED

pulses.

The first recommendation is to use two power supplies; one for

the device VDD and the other for the IR LED. In many systems,

there is a quiet analog supply and a noisy digital supply. By

connecting the quiet supply to the VDD pin and the noisy supply

to the LED, the key goal can be meet. Place a 1-

μF low-ESR

decoupling capacitor as close as possible to the VDD pin and

another at the LED anode, and a 22-

μF capacitor at the output

of the LED voltage regulator to supply the 100-mA current

surge.

Figure 43:

Proximity Sensing Using Separate Power Supplies

Application Information

Hardware

TSL2771

INT

SDA

SCL

VDD

LDR

Voltage

Regulator

Voltage

Regulator

. 22 mF

* Cap Value Per Regulator Manufacturer Recommendation

IR LED

GND

VBUS

RPI

TSL27711 数据表(PDF) 39 Page - OSRAM GmbH

TSL27711 数据表(HTML) 39 Page - OSRAM GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51

数据表下载