 2004 Microchip Technology Inc.

DS21109F-page 3

37LV36/65/128

2.0

DATA

2.1

Data I/O

Three-state DATA output for reading and input during

programming.

3.0

CLK

3.1

Clock Input

Used to increment the internal address and bit counters

for reading and programming.

4.0

RESET/OE

4.1

Reset Input and Output Enable

A LOW level on both the CE and RESET/OE inputs

enables the data output driver.

A HIGH level on

RESET/OE resets both the address and bit counters.

In the 37LVXXX, the logic polarity of this input is pro-

grammable as either RESET/OE or OE/RESET. This

document describes the pin as RESET/OE although

the opposite polarity is also possible. This option is

defined and set at device program time.

5.0

CE

5.1

Chip Enable Input

CE is used for device selection. A LOW level on both

CE and OE enables the data output driver. A HIGH

level on CE disables both the address and bit counters

and forces the device into a low power mode.

6.0

CEO

6.1

Chip Enable Output

This signal is asserted LOW on the clock cycle follow-

ing the last bit read from the memory. It will stay LOW

as long as CE and OE are both LOW. It will then follow

CE until OE goes HIGH.

Thereafter, CEO will stay

HIGH until the entire EPROM is read again. This pin

also used to sense the status of RESET polarity when

Programming Mode is entered.

7.0

VPP

7.1

Programming Voltage Supply

Used to enter programming mode (+13 volts) and to

program the memory (+13 volts). Must be connected

directly to Vcc for normal Read operation. No over-

shoot above +14 volts is permitted.

8.0

CASCADING SERIAL EPROMS

Cascading Serial EPROMs provide additional memory

for multiple FPGAs configured as a daisy-chain, or for

future applications requiring larger configuration mem-

ories.

When the last bit from the first Serial EPROM is read,

the next clock signal to the Serial EPROM asserts its

CEO output LOW and disables its DATA line. The sec-

ond Serial EPROM recognizes the LOW level on its CE

input and enables its DATA output.

When configuration is complete, the address counters

of all cascaded Serial EPROMs are reset if RESET

goes LOW forcing the RESET/OE on each Serial

EPROM to go HIGH. If the address counters are not to

be reset upon completion, then the RESET/OE inputs

can be tied to ground.

Additional logic may be required if cascaded memories

are so large that the rippled chip enable is not fast

enough to activate successive Serial EPROMs.

9.0

STANDBY MODE

The 37LVXXX enters a low-power Standby Mode

whenever CE is HIGH. In Standby Mode, the Serial

EPROM consumes less than 100

µA of current. The

output will remain in a high-impedance state regardless

of the state of the OE input.

10.0

PROGRAMMING MODE

by driving a LOW on both CE and OE and then remov-

ing power from the device. Figures 4 through 7 show

the programming algorithm.

11.0

37LVXXX RESET POLARITY

The 37LVXXX lets the user choose the reset polarity as

either RESET/OE or OE/RESET. Any third-party com-

mercial programmer should prompt the user for the

desired reset polarity.

The programming of the overflow word should be han-

dled transparently by the EPROM programmer; it is

mentioned here as supplemental information only.

The polarity is programmed into the first overflow word

location, maximum address+1.

00000000 in these

locations makes the reset active LOW, FFFFFFFF in

these locations makes the reset active HIGH.

The

default condition is RESET active HIGH.